Applying Drylok To Basement Walls

Drylok is a popular brand of masonry waterproofing sealant that can be used to protect basement walls from moisture and water damage. It is a water-based sealant that penetrates the pores of the concrete and forms a waterproof barrier. Drylok can be applied to both interior and exterior concrete surfaces and is available in a variety of colors. It is also mildew-resistant and can help to prevent the growth of mold and mildew.

Applying Drylok to basement walls is not a difficult task and can be completed in a few hours. However, it is important to prepare the surface properly and to follow the manufacturer's instructions carefully. The following steps will show you how to apply Drylok to basement walls:

1. Prepare the Surface

The first step is to prepare the surface of the basement walls. This involves cleaning the walls of any dirt, dust, or debris. You can use a broom or a vacuum cleaner to remove loose debris. Once the walls are clean, you should use a sponge or a brush to apply a cleaning solution to the walls. The cleaning solution should be made with one part bleach to four parts water. Allow the cleaning solution to sit on the walls for 10 minutes and then rinse the walls with clean water. Allow the walls to dry completely before applying Drylok.

2. Apply the First Coat of Drylok

Once the surface is prepared, you can apply the first coat of Drylok. Use a paintbrush or a roller to apply the Drylok to the walls. Be sure to apply the Drylok evenly and to avoid leaving any streaks or drips. Allow the first coat of Drylok to dry completely before applying the second coat.

3. Apply the Second Coat of Drylok

Once the first coat of Drylok is dry, you can apply the second coat. Apply the second coat in the same manner as the first coat. Allow the second coat of Drylok to dry completely before moving on to the next step.

4. Allow the Drylok to Cure

Once the second coat of Drylok is dry, you need to allow it to cure. The curing time for Drylok is 24 hours. During this time, you should avoid touching the Drylok or exposing it to moisture. Once the Drylok has cured, it will be fully waterproof.