How To Remove Rusted Basement Drain Cover

A rusted basement drain cover can be a frustrating problem. But by following the steps below, you can remove it quickly and easily.

Step 1: Gather your tools. You will need the following tools to remove a rusted basement drain cover:

A pair of pliers
A screwdriver
A hammer
A bucket or container
WD-40

Step 2: Lubricate the drain cover.

Apply WD-40 to the bolts or screws located around the drain cover using a spray lubricant. Work plastic back and forth until it can be removed by hand.

Step 3: Loosen the bolts or screws.

Loosen the bolts or screws that are holding the drain cover in place using a screwdriver. If the bolts or screws are rusted, you may need to use a hammer to loosen them.

Step 4: Remove the drain cover.

Once the bolts or screws are loose, you can remove the drain cover by pulling it straight up.

Step 5: Clean the drain cover.

Once the drain cover is removed, clean it thoroughly with a wire brush and a degreaser. This will remove any rust or debris that may have accumulated on the cover.

Step 6: Reinstall the drain cover.

Once the drain cover is clean, you can reinstall it by following the steps in reverse order.

Step 7: Tighten the bolts or screws.

Tighten the bolts or screws that are holding the drain cover in place using a screwdriver. Make sure that the bolts or screws are tight enough to prevent the drain cover from moving, but not so tight that they strip the threads.

Step 8: Clean up.

Once the drain cover is reinstalled, clean up any debris that may have been created during the removal process.