How To Replace A Sump Pump In A Basement

How to Replace a Sump Pump in a Basement

Sump pumps are essential for keeping basements dry and free from flooding. If your sump pump fails, it can lead to costly water damage. That's why it's important to know how to replace a sump pump if it ever goes out.

Replacing a sump pump is not a difficult task, but it does require some basic plumbing skills. If you're not comfortable working with plumbing, it's best to call a licensed plumber to do the job.

Here are the steps on how to replace a sump pump:

Materials you will need:

New sump pump
Wrench
Screwdriver
Pliers
Basin wrench
Teflon tape
Electrical tape
Check Valve

Step 1: Turn off the power to the sump pump.

The sump pump is usually plugged into an electrical outlet. Unplug the sump pump or turn off the breaker that powers it.

Step 2: Disconnect the discharge pipe.

The discharge pipe is the pipe that carries water away from the sump pump. It is usually connected to the sump pump with a hose clamp. Loosen the hose clamp and disconnect the discharge pipe.

Step 3: Remove the old sump pump.

The sump pump is usually held in place by a few bolts. Remove the bolts and lift the sump pump out of the sump basin.

Step 4: Clean the sump basin.

The sump basin should be cleaned before installing the new sump pump. Use a bucket or wet/dry vac to remove any dirt or debris from the basin.

Step 5: Install the new sump pump.

Place the new sump pump in the sump basin. Make sure that the pump is level. Tighten the bolts to secure the pump in place.

Step 6: Reconnect the discharge pipe.

Attach the discharge pipe to the sump pump. Use a hose clamp to secure the connection.

Step 7: Connect the power to the sump pump.

Plug the sump pump into an electrical outlet or turn on the breaker that powers it.

Step 8: Test the sump pump.

Pour a bucket of water into the sump basin. The sump pump should turn on and pump the water out of the basin.

Step 9: Check the check valve.

The check valve is a small device that prevents water from flowing back into the sump pump. Make sure that the check valve is installed correctly. The arrow on the check valve should point away from the sump pump.

Replacing a sump pump is a relatively easy task that can be completed in about an hour. By following these steps, you can keep your basement dry and free from flooding.